[Review] CCUQ SPL2 MBDC

Which is the correct maximum oil level of IGB on below picture

Which is the correct maximum oil level of TGB on below picture

Which is the correct minimum oil level of IGB on below picture

Which is the correct minimum oil level of TGB on below picture

The symbol indicate that material must be used

The symbol indicate that material must be used

The symbol indicate that

The symbol indicate that

The symbol indicate that

The symbol in Aircraft Maintenance Manual (MMA) indicate that

The symbol in Aircraft Maintenance Manual (MMA) indicate that

The symbol in Aircraft Maintenance Manual (MMA) indicate that

The symbol in Aircraft Maintenance Manual (MMA) indicate that

The angle of attack of a blade is the

The tail rotor

With a drop in ambient temperature, an aircraft service ceiling will

The autorotation

The lift of main rotor blade is generated by

The main rotor blades are prevented from ‘folding up’ during flight by

A helicopter tail fin helps to give

The purpose of the horizontal stabilizer is to

If the blade angle of attack increases

When airflow velocity over an upper cambered surface of an airfoil decreases, what takes place

Changes in aircraft weight

Ground effect will be most apparent when

The rotor disk is

If the rotor disk is tilted then the helicopter will

The primary purpose of the tail rotor is

What is the purpose of flapping restrainers

What position are the droop stops during flight

Tail rotors are positioned in the same horizontal plane as the main rotor head to

A fully articulated rotor head would incorporate

Drag dampers

Flapping of blades is with respect to

When raising the collective lever

The rotor head is driven by the engine through

The ability of the blade to move up and down is

The collective lever controls

The collective control adjusts the pitch angle of the rotor blades

If the center gravity (CG) of a helicopter is after of its permitted range it will

A tracking check is to ensure that

Tracking on a helicopter means

What causes lateral vibration

The purpose of the scissor links on a swash plate are

A rotor brake is located

Corrosion caused by electrolytic action is the result of

What is stress corrosion

Jointing compound is used for what reason

What action is taken to protect the fuel tanks from corrosion due to micro-biological growth

Surface corrosion on stainless steel is identified by

What colour is the corrosion found on the surface of aluminium alloys

Rubber components should be stored

When degreasing aluminium alloys, and no trichloroethylene is available, a suitable alternative is

Electrochemical reaction is caused by the contact of

In a free turbine

The highest pressure in a gas turbine is

A modular constructed gas turbine engine means that

At what stage in a gas turbine engine are gas pressures the greatest

Through turbine rotor blades

What are the two main functional components in a centrifugal compressor

What is one purpose of the stator blades in the compressor section

The purpose of a bleed valve, located in the beginning stages of the compressor, in an aircraft gas turbine engine is to

The energy changes that take place in the impeller of a centrifugal compressor are

Bleed valves are

Variable inlet guide vanes prevent

An axial compressor surges when

What purpose do the diffuser vanes of a centrifugal compressor serve

Air through the compressor, before entering the combustion chamber, passes

A bleed valve

Inlet guide vanes are fitted to

What is a compressor stage

The diffuser after the compressor, before the combustion chamber

Type of the compressor of the gas turbine engine

What section provides proper mixing of the fuel and efficient burning of the gases

The highest pressure in a gas turbine engine

Which law relates to the kinetic, pressure, and potential energy in a fluid flow

Power is adjusted in a gas turbine engine by

An electric current

The international system of units (S.I) unit of power

The international system of units (S.I) unit of electric current

The international system of units (S.I) unit of voltage

The international system of units (S.I) unit of resistance

The purpose of bonding is to

On helicopter, the thermocouple is used to measure

An ammeter is connected into a circuit in

An voltmeter is used to measure

An ammeter is used to measure

An ohmmeter is used to measure

The gas turbine engine comprises

Function of the air intake of the gas turbine engine

Function of the compressor of the gas turbine engine

Function of the combustion chamber of the gas turbine engine

Function of the turbine of the gas turbine engine

Function of the exhaust nozzle of the gas turbine engine

Type of air intake, classify by air inlet flow velocity

Type of the compressor of the gas turbine engine

Bernoulli’s Theorem states that at any point in a flow of gas

As subsonic air flows through a convergent nozzle the velocity

The pressure of subsonic air as it flows through a convergent nozzle

Newton’s First Law of Motion, generally termed the Law of Inertia, states

A divergent duct will cause subsonic flow to

In a gas turbine engine, gas pressures is greatest at

Which of the following is the ultimate limiting factor of turbine engine operation

Power is adjusted in a gas turbine engine by

The main factor considered when designing an engine is

The hottest component in a gas turbine engine

The efficiency of a gas turbine would be greatest at

In a gas turbine engine, at turbine section

Temperature of the mass airflow through a gas turbine engine

The intake of a gas turbine engine is designed to

With rise in temperature, the resistance of semi-conductors

Which is the best conductor of electricity

To decrease resistance of electric wire

The flight limitation and emergency procedures are described in?

Which documents used for helicopter maintenance?

The Master Servicing Manual (MSM) belongs to:

What is the abbreviation document “ICO” means?

What is the abbreviation document “IPC” means?

What is the abbreviation document “MTC” means?

What is the abbreviation document “MCS” means?

What is the abbreviation document “ALS” means?

What is the abbreviation document “MSM” means?

Which statement below about Master Servicing Manual (MSM) defined is correct?

Which statement below about Airworthiness Limitations Section (ALS) defined is correct?

Which statement below about the Flight Manual (PMV) defined is correct?

Which statement below about Master Minimum Equipment List (MMEL) defined is correct?

How many types of hard time maintenance limits for AS332 L2?

Which statement below about main maintenance modes is correct?

Which statement below about MMA defined is correct?

Which document is intended for flight crews?

Which statement below about IPC defined is correct?

Which statement below about ICO defined is correct?

Arrange the following special documents in ascending order of importance?

The purpose of Information Notices (IN) and Safety Information Notices (SIN) is:

Landing Cycle (LC) is calculated:

The operating time limits, intervals and schedules inspections are listed in?

Which section lists the maintenance operations and their intervals in all the aircraft operating conditions?

The section lists the components subject to an Operating Time limit (OTL) or to a limited Time Between Overhauls (TBO) is showed at:

Airbus Helicopters recommends to plan the maintenance operation

Which documentation determines the minimum equipment necessary to fly in accordance with the specific operating conditions?

An aircraft operator’s MEL

A Master Minimum Equipment List (MMEL) is

The MMEL contains an additional note (M) indicates a

The Master Minimum Equipment List (MMEL) is approved by?

The Master Minimum Equipment List (MMEL) is developed by?

An inoperative item may be removed from the aircraft if allowed by?

The MMEL establishes limitations on the duration of and conditions for operation with inoperative items to

Which statements below are correct about Minimum Equipment List?

When an Operator (VNHS) developing the MEL, compliance with:

What is the symbol “M” in the MEL indicate?

What is the symbol “O” in the MEL indicate?