[Review] VNHS/VAR/AW189/MBDC – LEVEL A

Maximum passenger seats on AW189:

The cabin door allows the opening and closing in flight at speed up to:

Which chapter is the retirment lives, mandatory inspection belong to?

Flight hours are caculated from:

The madatory inspection is permitted using inspection interval tolerances?

Which chapter is the time limits belong to?

How is the next inspection after using the inspection interval tolerance?

In chapter 05, the time limit is divided into:

Can the discard time schedule be applied the tolerance?

Reference lines along Z axis:

The reference planes are corresponding to the helicopter’s length:

The reference planes are corresponding to the helicopter’s width:

The helicopter can be lifted through a sling secured to:

Which circuit breaker of system has to be off before jacking the helicopter?

What must be paid attention when weighing the helicopter?

Where is the leveling tool placed on the helicopter?

Maximum speed limitation when taxiing on paved surfaces:

Maximum ground speed for wheel brake application:

The main rotor blades tie-down must be installed when:

Park the helicopter in a safe area when:

Which statement below is correct about main rotor blades tie-down:

The MGB oil is drained:

The IGB and TGB oil is drained:

The PCM hydraulic is drained:

The replaceable parts can be found in:

The inspection requirements, maintenance procedures, removal and installation procedures, test and inspection can be found in:

The airborne equipments which are mandatory to achieve a safe flight condition can be found in:

Function of the ECS check valve:

When the temperature control valve is fully closed (during normal operation or if failed closed), a minimum heating air flow is provided through:

ICS operating modes:

The purpose of remote memory unit on the ICS system:

Which indications are there on cockpit audio control panel?

What bus bars are not supplied power if only one generator operated?

The APU can operate in flight or on the ground within:

The starter generator is installed on:

The two Starter Generator Control Units (SGCUs) are located:

AW189 is equipped with:

ECS bus is powered in flight:

Which LRU stops the start cycle of the starter generator, removing the start command from the SGCU?

Operation of the automatic deployable emergency locator transmitter:

In case of helicopter ground crash, automatic deployment of the crash position indicator beacon is activated by:

The CPI beacon is installed on:

Which light will illuminate on the ADELT CCP after ADELT is activated?

The smoke detector is installed in:

The fire protection system is equipped for:

Type of engines and APU fire detection:

Which statement below is correct?

The fire extinguisher discharge indicator:

Indications when engine fire:

Indications when APU fire:

What kind of fuel boost pump does the AW189 use?

What is the purpose of the non-return fuel valve?

What is the purpose of the false connector?

How many high level fuel switches are there in fuel system?

If the fuel pressure in feed line drops below the preset value, which does activate the crossfeed valve (in auto crossfeed mode)?

Where is the fuel flow displayed?

Press the “pre-check” button on refuel control panel, if the high-level float switch is functioning, what does happen?

How many hydraulic pumps are used on AW189?

The hydraulic electrical pump No.3 can operate:

The hydraulic electrical pump No.3 can operate:

When hydraulic pump No.2 failed:

Hydraulic system 2 fluid level at 40%:

Hydraulic system 2 fluid level at 28%:

Hydraulic system 2 fluid level at 22%:

Hydraulic system 1 fluid level at 40%:

Hydraulic system 1 fluid level at 28%:

Hydraulic system 1 fluid level at 22%:

Electrical power of pitot heating elements:

The crew can set the wiper and the wiper wash operation mode by using:

The crew can set the wiper ON/OFF operation by using:

What is the purpose of the ULB?

How long the CVFDR continue to record audio signal if the power off?

What happen to the CVFDR data if pressed ERASE button more than 2s?

The CVFDR records voice data:

Which statement below are correct:

The nose landing gear:

Normal operation of the landing gears is performed by using:

Emergency extension of the landing gears is performed by using:

The nose landing gear is extended:

Which statement below are correct:

The main landing gear is extended:

Weight on wheels (WOWs) proximity switches are fitted on:

CAS message “RH LDG LT ON” presented in green and the “LH LDG LT EXTD” presented in white indicate that the right landing light is on:

What is the CCJ (cursor control joystick) used for?

What are the ECDU operating modes?

Main purpose of the microturbo e-APU 60:

The APU can operate the environment control system:

The APU fuel filter is equipped with:

Function of the fuel metering pump (FMP):

Function of the fuel flow divider manifold:

How many APU burners in total?

Function of high pressure relief valve:

The APU oil filter is equipped with:

Type of the APU electric starter motor (ESM):

The APU bleed air can performed:

The APU cranking:

The crew door consist of:

The passenger doors consist primarily of:

The door is not monitored by position microswitch:

The fuselage is divided into:

The main cabin is constructed of:

The maximum weight that can be loaded in baggage compartment is:

The connection between rear fuselage and tail unit by:

The vertical fin improves the the aerodynamic stability along:

The cabin windows can be jettisoned in case of emergency by:

Material of the the flight compartment windshield:

The AW189 main rotor blade is made predominantly from:

The components permit lead-lag, flap and pitch change movement of the MR blade is:

The main rotor hub is made of:

What is the function of the droop stop assembly?

What is type of the MR lag damper?

What is the function of the beanie?

The MRH azimuth sensor is installed on:

How many reduction stages in MGB?

What are the purposes of the coupling assembly?

The anti-torque beam is made of:

The function of anti-torque beam is:

The MGB consist of:

The MGB upper casing is attached to the structure by:

How many magnetic chip detectors (MCD) are there in the MGB?

Which statement below about MCD of the MGB is correct?

The pilots can operate the fuzz burner to burn off any very small particles using:

The oil filter differential pressure transducer measures the difference in pressure between the oil filter inlet and outlet and generate:

Which following condition can activate the MGB low oil level switch?

Which is the most critical part in the input module?

In case of the loss of oil in the lubrication system, the emergency oil system will lubricate:

Which statement below about emergency oil system is correct?

The rotor brake actuator caliper is automatically raised to the braking position when the aircraft is on the ground and:

When is the rotor braking operation permitted?

The components permit lead-lag, flap and pitch change movement of the TR blade is:

What is type of the TR damper?

Which components transfer the rotating motion of the hub about the mast axis to the spider and slider assembly?

Which statement below about the TR pitch links is correct?

Total number of tail rotor drive shaft sections?

The first tail drive shaft is made of:

The damper assembly is fitted on:

The function of the damper assembly:

Which are the drive shafts made of anodized aluminum alloy?

The IGB is a bevel gearbox that changes:

The IGB lubrication type:

The IGB and TGB lubrication oil is monitored by:

The oil low-level sensor of IGB and TGB only operates when:

The rotors flight control is transmitted:

The mixing unit combines the output from:

The forward sliding cowling is attached by means of:

The rear sliding cowling is attached by means of:

Engines on AW189 is:

The compressor consists of:

The inlet particle separator (IPS) is designed to:

The interturbine temperature (ITT) is designated:

The CT7-2E1 engine consists of:

The function of the scroll case:

The permanent magnet alternator (PMA) which makes the engine independent of the aircraft’s power generation systems once:

The differential pressure across the filter to activate the fuel filter bypass switch:

The engine maximum fuel flow is limited by:

Parameters are used for computation of engine fuel flow:

When the engine shutdown, fuel inside the manifold and injectors is blown back by:

Power is supplied to the ignition exciter assembly by:

Permanent magnetic alternator (PMA) has:

At engine maximum power:

Starting bleed modulation is controlled as a function of:

The (T2) temperature signal is sent to the EECU for:

The P3 air pressure signal is sent to the EECU for:

The P0 sensor is used for:

All of the sump seals are pressurized by:

The air/oil separator is located in:

Two TQ/NP sensors are located in:

The ITT (T4.5) temperature signal are measured by:

Colored bands within the scale in black indicate: